ACCELS Setting for CP Motion
To make the Manipulator move in a CP motion, make the appropriate ACCELS settings in the SPEL program based on the tip load and Z-axis height.
Note
If the ACCELS settings are not properly configured, the following problem may occur.
- Shortened lifespan and damage to the ball screw spline
Set ACCELS as shown below based on the Z-axis height.
ACCELS setting values by the Z-axis height and tip load
| Z-axis Height (mm) | Tip load | |
|---|---|---|
| 0.5 kg or less | 1 kg or less | |
| - 0 > Z ≥ - 50 | 25000 or less | 18000 or less |
| - 50 > Z ≥ - 100 | 22000 or less | 11000 or less |
| Symbol | Description |
|---|---|
| a | Z-axis height 0 (origin position) |
Also, if a CP motion was performed with incorrect values set, check the following point.
- No deformation or bending of the shaft of the ball screw spline