Power Connection
CAUTION
- Before supplying power to the part feeder, make sure that the distribution voltage is the same as the nominal voltage.
- Never disconnect the power cable when the unit is on. Always turn the machine off before disconnecting the power cable.
- Use PELV (protected extra-low voltage) nominal voltage.
- Unplug the main power plug when plugging / unplugging cords.
Power Connection
| Pin | Signal description | Cable |
|---|---|---|
| (1) | 24VDC PELV S-Power | L+ |
| (2) | 0V GND S-Power | L- |
| (3) | EARTH | PE |
| (11) | 24VDC PELV Power | Black |
| (12) | 0V GND Power | White |
| (13) – (14) | Not used |
Connector type of IF-530 side: M16, 5 poles, male
| Characteristic | Value |
|---|---|
| Voltage | +24VDC ±5% |
| Power Current | 6A |
| S-Power Current | 14A |
KEY POINTS
S-Power is the safety power for the backlight. Cutting this S-Power ensures that the backlight stays off. (e.g. to avoid danger from an infrared backlight)
The following connection schematics show how to connect the IF-240 depending on whether your application uses an external relay to ensure that the backlight is safely switched off. In either case, both “Power” and “S-Power” must be supplied when using the backlight.
| Symbols | Meaning |
|---|---|
| a | Power connection without safety relay |
| b | Power connection with safety relay |
KEY POINTS
Both Power and S-Power can be connected to a single power supply or to two different power supplies.