Epson RC+ 8.0 Option Remote Control Reference
- 010
  - FOREWORD
    - 010-010
- 020
  - Before Reading This Manual
    - 020-010
- 030
  - Remote I/O to Be Used
    - 030-010
- 040
  - Configuration
    - 040-010
      
      Configuration
      Selecting the Control Device
      Setting the Control Signals
      040-010-030
      
      Setting the Input Signals
      Setting the Output Signals
      Setting the Data Signals
      040-010-040
      
      Setting the Command Signals
      Setting the Response Signals
- 050
  - Control Method
    - 050-010
- 060
  - Response Codes
    - 060-010
- 070
  - Command List
    - 070-010
- 080
  - Basic Command Usage
    - 080-010
- 090
  - Command Reference
    - 090-010
    - 090-020
    - 090-030
    - 090-040
    - 090-050
    - 090-060
    - 090-070
    - 090-080
    - 090-090
    - 090-100
    - 090-110
    - 090-120
    - 090-130
    - 090-140
    - 090-150
    - 090-160
    - 090-170
    - 090-180
    - 090-190
    - 090-200
    - 090-210
    - 090-220
    - 090-230
    - 090-240
    - 090-250
    - 090-260
    - 090-270
    - 090-280
    - 090-290
    - 090-300
    - 090-310

Configuration

To enable this function, you must configure the Controller beforehand.

Set each signal described in the following in Epson RC+ 8.0.

Remote I/O to Be Used

← Configuration Selecting the Control Device →