Robot Power

The status of robot power is explained below in terms of restriction to operation:

Operation-prohibited status:

Robot cannot be operated.

Restricted (low power) status:

Robot can operate at low speed and low torque.

Unrestricted (high power) status:

Robot can operate without restriction.

The robot will not operate regardless of the control actions taken by the operator when in the operation-prohibited state. During operation, when the safeguard circuit opens, the system will switch to operation-prohibited state.

The robot will operate at low speed and torque in the restricted state (low power). In the unrestricted state (high power), the robot will operate at the programmed speed and torque.

In the event that the robot should make an unexpected movement, the restricted state (low power) decreases operating speed allowing the operator to avoid danger. The torque is also decreased to minimize serious injury to the operator should one be struck by the robot. The maximum values of the decreased speed and torque are set according to the robot used and cannot be changed by the user.

As a safety precaution the initial power state of the robot will be set to either the restricted (low power) state or the operation-prohibited state. The system will not change to the unrestricted (high power) state if the appropriate procedures are not followed.

Due to the multi-protect circuit and mutual monitoring circuit in the controller, when the system is in a restricted state (low power state) or operation-prohibited state, even a single failure will not cause runaway operation exceeding the specified reduced speed and reduced torque.