Epson RC+ 8.0 Option Remote Control Reference
- 010
  - FOREWORD
    - 010-010
- 020
  - Before Reading This Manual
    - 020-010
- 030
  - Remote I/O to Be Used
    - 030-010
- 040
  - Configuration
    - 040-010
- 050
  - Control Method
    - 050-010
- 060
  - Response Codes
    - 060-010
- 070
  - Command List
    - 070-010
- 080
  - Basic Command Usage
    - 080-010
      
      Basic Command Usage
      Using Speed and Acceleration Tables
      Command Execution Procedure
      Parallel Processing Lists
- 090
  - Command Reference
    - 090-010
    - 090-020
    - 090-030
    - 090-040
    - 090-050
    - 090-060
    - 090-070
    - 090-080
    - 090-090
    - 090-100
    - 090-110
    - 090-120
    - 090-130
    - 090-140
    - 090-150
    - 090-160
    - 090-170
    - 090-180
    - 090-190
    - 090-200
    - 090-210
    - 090-220
    - 090-230
    - 090-240
    - 090-250
    - 090-260
    - 090-270
    - 090-280
    - 090-290
    - 090-300
    - 090-310

Parallel Processing Lists

Some motion commands can control ON/OFF of the specified I/O in parallel with motion based on the specified progress rate. To enable this function, register the parameter lists for parallel processing beforehand, and set the list numbers to be used. There are 16 lists available, and one of them is used to register the processes against progress of 16 lists.

Registration and selection of the lists can be done with commands from No. 1300 to 1304.

CAUTION

Registered data in lists will be cleared when the Controller is turned OFF or reset.

← Command Execution Procedure Command Reference →