RS-232C Software Configuration
To configure a Windows Part RS-232C port
The [System Configuration] command opens a dialog that contains several pages that are used to configure the system for the Epson RC+ 8.0 environment.
Select [Controller]-[RS-232]-[PC].
Set the [Enabled] check box.
Change the settings as desired.
Click the [Apply] button. The new settings are saved.
Click the [Close] button.
KEY POINTS
If several ports are used for communication at one time with more than a 19200 baud rate, error 2929 or 2922 may occur. In this case, select a lower baud rate or avoid using several ports at one time.
To configure a standard / option RS-232C port
The [System Configuration] command opens a dialog that contains several pages that are used to configure the system for the Epson RC+ 8.0 environment.
Select [Controller]-[RS-232]-[CU].
Select a port to configure.
Change the settings as desired.
Click the [Apply] button. The new settings are saved.
Click the [Close] button.