Industrial Robot: 6-Axis Robots VT-B series Manual
- 005
  - Introduction
    - 005-010
    - 005-020
    - 005-030
    - 005-040
    - 005-050
    - 005-060
    - 005-070
    - 005-080
    - 005-090
    - 005-100
- 010
  - Installation
    - 010-010
      
      Safety
      010-010-010
    - 010-020
      
      Installation
      010-020-010
    - 010-030
      
      Power On
      010-030-010
    - 010-040
      
      First Step
      010-040-010
      
      Installing Epson RC+ Software
      Development PC and Manipulator Connection
      010-040-010-020
      
      Writing Your First Program
    - 010-050
      
      Second Step
      010-050-010
- 020
  - VT6-B Manipulator
    - 020-010
    - 020-020
    - 020-030
    - 020-040
    - 020-050
    - 020-060
    - 020-070
    - 020-080
    - 020-090
    - 020-100
    - 020-110
    - 020-120
    - 020-130
    - 020-140
    - 020-150
    - 020-160
    - 020-170
    - 020-180
- 030
  - Periodic Inspection
    - 030-010
- 040
  - Appendix
    - 040-010
    - 040-020
    - 040-030

First Step

This section presents the procedure for installing Epson RC+ to the development PC, connecting the development PC and the Controller by USB, and executing a simple program.
Make sure that the Robot system is installed safely by the description in “1. Safety” and “2. Installation”. Then, operate the Robot system in the following procedures.

← Power On Procedure Installing Epson RC+ Software →