Development PC and Manipulator Connection

Connect the development PC and the development PC connection port.

For the connector position, refer to the following section.

Part Names

KEY POINTS

---

• For other details on connecting the development PC and Manipulator, refer to the following manual:
  Epson RC+ User’s Guide “[PC to Controller Communications] (Setup Menu)”.
• Be sure to install the Epson RC+ to the development PC first, then connect the development PC and Manipulator with the USB cable. If the Manipulator and the development PC are connected without installing the Epson RC+ to the development PC, [Add New Hardware Wizard] appears. If this wizard appears, click the [Cancel] button.