Pneumatic Tubes
| Maximum Working Pressure | Number of Tubes | Outer Diameter × Inner Diameter |
|---|---|---|
| 0.59 MPa (6 kgf/cm2: 86 psi) | 2 | ⌀6 mm × ⌀4 mm |
Standard model, Cleanroom model:
The elbow fitting is attached on the Arm #4 at the time of shipment. The part can be replaced with the straight fitting (accessory) according to application.
Protected-model:
The plugs are installed on the Arm #4 and the base. To use the pneumatic tubes, remove the plugs and install the fittings (accessory) on the Arm #4.
Threaded hole size for installing the Arm #4 fitting: M6
When the Manipulator is a protected-model, please note the following points.
CAUTION
- In special environments (e.g., oil smoke, dust, etc.), the user wires and pneumatic tubes should have protected-model (compliant with protection class IP67). If the user wires and pneumatic tubes not protected-model are connected, the protection class (IP67) cannot be guaranteed, and the Manipulator may be damaged or break down.
- Be sure to attach the cap or plug (attached at the time of shipment) on the user cable connector when not using the user cable connector or the pneumatic tubes. Using the Manipulator without the cap or plug may cause equipment damage to and/or malfunction of the Manipulator as dust or oily smoke gets into the connector.