Epson RC+ 8.0 Software Installation
The Epson RC+ 8.0 software needs to be installed on your development PC.
First, make sure your PC is connected to the Internet.
Insert the software disk attached to the product into your PC. Run EpsonRobotSoftwareInstallerSetup.exe on the disk and follow the on-screen instructions to begin installation.
KEY POINTS
For installation instructions for Epson Robot Software Installer, refer to the Epson Robot Software Installer manual on your disk.
If you save and install the Epson RC+ setup file from the Internet, the latest software and manuals will be installed.
During installation, it will be displayed in the language according to your settings in [Control Panel]-[Clock and Region]-[Region]-[Formats].
However, depending on the country you selected at the Region setting, it may be displayed in English.
Check the RC+ version you want to install and click the [Next] button.
The window shown below appears. Check the content and click the [Next] button.
After reviewing the software license agreement, select “I accept all terms of the license agreement” and click the [Next] button.
Specify where to install the Epson RC+ 8.0 software. If necessary, click the [Browse] button to change the installation location.
Specify where to install the project and other data. If necessary, click the [Browse] button to change the installation location.
The dialog for selecting the options to be installed will be displayed.
Check the options you want to install and click the [Next] button.
Select the tasks to execute and click the [Next] button.
The dialog to review the settings will be displayed.
If you are satisfied with the settings, click the [Next] button.
After the installation is completed, the following screen will be displayed.
KEY POINTS
The system may restart.