Base Side Fittings
Using the base side fittings to the C4 Manipulator base, you can mount the Manipulator in the place where limits the mounting height or use the open room for the base.
Mounting image using the base side fittings
For the information on how to mount and precautions, refer to the following section.
Environment and Installation
| Parts Included | Qty. | |
|---|---|---|
| a | Base side plate | 2 |
| b | Pin | 2 |
| c | Hexagon socket head cap bolt M8×60 | 4 |
To mount the base side plate
KEY POINTS
For details of tightening the hexagon socket head cap bolt, refer to the following section.
- Drive the pins to the base side plate.
Protruding part of pins is approx. 2 to 5 mm.
- Mount the base side plate with the pins driven to the both sides of the base.
Fit the pins with the holes and secure the base side plate by pressing it from above to the base fixing part. (With the steps above, the both surfaces of base side fittings can be stable.)
Dimension of the Manipulator with the base side fittings
* 2×M10 (prepared threaded hole ⌀8.5)
Mounting example
Screws
| Size | Recommended Length | |
|---|---|---|
| A | M8 | 30 mm or more |
| B | M10 | 15 mm + base plate or more |
KEY POINTS
The base side plate has a M10 threaded hole. You can secure the plate with a M10 screw or a M8 screw by using the prepared screw hole of ⌀8.5 to make a M8 screw hole on the mounting surface.
KEY POINTS
When you install the Manipulator for practical use, you need to insert the screws in the right/left side from the same direction (above or below).
Table top mounting
| Symbol | Description |
|---|---|
| a | B: Secures from below |
| b | A: Secures from below |
| c | Base plate (Table top) |
| d | B: Secures from above |
| e | A: Secures from above |
Ceiling mounting
| Symbol | Description |
|---|---|
| a | A: Secures from below |
| b | B: Secures from below |
| c | Base plate (Ceiling) |
| d | A: Secures from above |
| e | B: Secures from above |