Replacing the Purging Actuator

CAUTION

---

Before replacing the actuator, unplug the purging frame from the feeder and remove it. (Four hand-tightened screws)

1. Remove the protective cover.

   4 screws Tx10

   

   

Symbols	Meaning
a	Protective cover

2. Cut the zip-tie, taking care not to damage the cables.

   

3. Unscrew the actuator block.

   3 screws Tx10

   

   Remove the actuator and disconnect it by pulling on the connector, not on the cable itself.

   

Symbols	Meaning
a	Actuator

4. Remove the retaining ring.

   Swap out the actuator block.

   Reattach the retaining ring.

   

Symbols	Meaning
a	Retaining ring
b	Actuator

5. Plug in the actuator block (1).

   Tighten the flap screw (2). (hold the flap in the closed position while screwing in)

   Screw in the bracket (3) with the flap still in held in the closed position.

   3 screws Tx 10, 1.2Nm

   

   

Symbols	Meaning
a	Actuator

6. Tie the cables together with a zip-tie.

   

7. Screw the protective cover back into position.

   4 screws Tx 10, 0.6 Nm

   

   

Symbols	Meaning
a	Protective cover