Calibration & Test

1. In the tree, click "Calibration".
   Then, click the [Calibrate & Test] button.
   

2. The [Calibrate & Test] wizard starts.
   Select [Part Area] tab.
   

3. Put one part in the center of the platform.

4. Click the [Run] button.

5. The next message is displayed.
   Click the [Yes] button.
   

6. Check the value displayed in the "Part Area".

7. Click the [Apply] button.

KEY POINTS

---

Following both Calibration (8) [Flip & Separate] and (14) [Region] are not necessary but recommend running calibration.

8. Select [Flip & Separation] tab.
   

9. Put the same number of parts that are displayed on the platform.

10. Click the [Run] button.

11. The next message is displayed.
    Click the [Yes] button.
    

12. After running feeder vibration and vision processing several times, check to confirm that each value in [Results] has been updated.

13. Click the [Apply] button.

14. Select [Region] tab.
    

15. Change the number of input parts to one.

16. Next message displayed.
    Click the [Run] button.
    

17. After running feeder vibration and vision processing several times, check to confirm that each value in [Results] has been updated.

18. Click the [Apply] button.