Overlap with the Part Feeder
The recommended overlaps for hoppers and part feeders are shown in the table below.
Recommended overlap (a) between the container and part feeder:
| IF-240 | IF-380 | IF-530 | |
|---|---|---|---|
| Hopper S | 5 mm (diagram A) | 5 mm (diagram B) | 5 mm (diagram B) |
| Hopper M | 5 mm (diagram A) | 5 mm (diagram B) | 5 mm (diagram B) |
| Hopper L | - | 5 mm (diagram C) | 5 mm (diagram C) |
Diagram A: Overlap between Hopper S/M and IF-240
Short side or long side
a: Recommended overlap between hopper and part feeder
Diagram B: Overlap between Hopper S/M and IF-380/IF-530
A: Short side / B: Long side
a: Recommended overlap between hopper and part feeder
Diagram C: Overlap between Hopper L and IF-380/IF-530
A: Short side / B: Long side
a: Recommended overlap between hopper and part feeder