Viewing the Maintenance Information

This section describes the procedure for viewing the Maintenance information that was set.

1. From the Epson RC+ menu, select [Tools] - [Controller] to display the [Controller Tools] dialog box.
   

2. To view the Maintenance information, click the [Maintenance] button to display the [Maintenance] dialog box.
   

3. Select a common or specified axis from the tree to display information on the target part.

KEY POINTS

---

• The recommended grease replacement interval is based on the number of days that have elapsed from the last grease application date. The replacement interval may vary depending on the customer's load and other usage methods.

• The recommended replacement interval for maintenance items (timing belt, motor, reduction gear, ball screw spline) is L10 life (period up to 10% breakage probability). In the [Maintenance] dialog box, the L10 life is shown as 100%.

• The number of months remaining is calculated based on the past operation conditions.

  The period used for the calculation can be set using the "HealthCalcPeriod" command. (Default: Controller power-on 7 days)

  The number of remaining months may not be calculated properly until the period used for calculation has elapsed once.