LED / SW Board

To replace the LED/SW board, follow the steps below.

1. Remove the top cover. (Refer to Hardware - Internal Structure of CV2 )
2. Remove four screws fixing the internal brackets.
3. Remove four screws fixing the front cover. (2 screws on the top face, 2 screws on the bottom face.)
   

Symbol	Description
a	Screws fixing the internal brackets
b	Screws fixing the front cover (Top face)
c	Screws fixing the front cover (Bottom face)

4. Remove the fitting screws on the both ends of following connectors using a nut driver.
   VGA / DVI-D / CON1 / CON2
5. Remove the front cover.
6. Remove the cables connected to the LED/SW board.
7. Remove two screws fixing the LED/SW board and remove the board.
8. Set the new LED/SW board and fix it in the reverse order to removal.
   

Symbol	Description
a	Remove the cables
b	Screws fixing the LED/SW board