Part Names and Functions
| No | Name | Functions |
|---|---|---|
| a | TRIGGER Switch | Refer to Hardware - CV2 TRIGGER Switch |
| b | STATUS LED | Refer to Hardware - CV2 LED Display |
| c | ERROR LED | Refer to Hardware - CV2 LED Display |
| d | PoE LED (1 to 4) | Refer to Hardware - CV2 LED Display |
| PoE Connector (4 ports) | Connectors for GigE cameras. Connect one GigE camera for each port. Up to four GigE cameras can be connected. Note: Do not connect the Ethernet hub or switch to the PoE port. | |
| e | Power LED | Refer to Hardware - CV2 LED Display |
| f | Power Switch | CV2 automatically starts up when 24V power source is applied. However, it does not turn ON automatically when the battery voltage is low. In this case, you can turn ON the CV2 by pressing this button. |
| g | Temperature Warning LED | Refer to Hardware - CV2 LED Display |
| h | CFast Access LED | Refer to Hardware - CV2 LED Display |
| i | 24V Input Connector | This connector is to supply 24V from 24V power source. |
| j | CON1 | This function is not available. Install the attached connector cover. |
| k | DVI-D Connector | A connector for the monitor which is compatible with DVI-D The monitors which only supports DVI-I cannot be connected to this connector. Same screen image is displayed for this connector and VGA connector (mirroring) |
| l | VGA Connector | A connector for the analog monitor. Same screen image is displayed for this connector and DVI-D connector (mirroring) |
| m | CON2 | This function is not available. Install the attached connector cover. |
| n | LAN Connector (2 ports) | Connectors for network hub and Robot Controllers GigE cameras cannot be connected. |
| o | USB Connector (4 ports) | Connectors for cameras, keyboard, and mouse. Remove the keyboard and mouse after installing as they may be influenced by the surrounding noise. Up to 2 cameras can be connected. |
| p | Fan Filter | A filter for the intake air fan. |
Installation environment (CV2/Camera)
In order to optimize the product’s performance for safety, CV2 and the camera(s) must be placed in an environment that satisfies the following conditions.
- Install indoors only and place in a well-ventilated area.
- Keep away from direct sunlight.
- Keep away from radiation heat.
- Keep away from dust, oily mist, oil, salinity, metal powder or other contaminants.
- Keep away from water.
- Keep away from shocks or vibrations.
- Keep away from sources of electronic noise.
- Prevent the occurrence of strong electric or magnetic field.
Mounting Direction (CV2)
The CV2 can be installed both horizontally and vertically (using the fixing brackets).
For fixing the CV2, use the attached fixing brackets and screws. Internal board may get damages if fixing the CV2 with the screws other than the attached ones.
Brackets installed on the bottom
Brackets installed on the side
KEY POINTS
Allow at least 50 mm from the wall to prevent blocking the fan filter and the air holes.
When installing the CV2 vertically, install it so as not to block ventilation of the air holes on the side where the fixing brackets are mounted.
Do not install the product near instruments with huge heating value.