Disconnection of Development PC and Manipulator

This section explains the procedure for disconnecting the development PC and the Manipulator.

1. From the Epson RC+ menu, select [Setup] - [PC to Controller Communications] to display the [PC to Controller Communications] dialog box.
2. Click the [Disconnect] button. After the [Disconnect] button is clicked, the Manipulator and the development PC are disconnected, and the USB cable can be removed.

KEY POINTS

---

The Manipulator stops when the USB cable is removed while the Manipulator and the development PC are connected. Be sure to click the [Disconnect] button in the [PC to Controller Communications] dialog box before removing the USB cable.