Precautions for Relocation and Storage
Observe the following when relocating, storing, and transporting the Manipulators.
Transportation and installation of the Manipulator and robotic equipment shall be performed by personnel who has taken robot system training held by us and suppliers and should conform to all national and local codes.
WARNING
- Only authorized personnel should perform sling work and operate a crane and a forklift. When these operations are performed by unauthorized personnel, it is extremely hazardous and may result in serious bodily injury and/or severe equipment damage to the robot system.
- Stabilize the Manipulator with your hands when hoisting it. If you lose balance, the Manipulator may fall which could result in serious bodily injury and/or severe equipment damage.
CAUTION
Before relocating the Manipulator, fold the arm and secure it tightly with a wire tie to prevent hands or fingers from being caught in the Manipulator.
When removing the anchor bolts, support the Manipulator to prevent falling. Removing the anchor bolts without support may result in the Manipulator to fall, and then get hands, fingers, or feet caught.
To carry the Manipulator, have two or more people to work on it and secure the Manipulator to the delivery equipment. Also, do not hold the shaded area in the figure. Doing so is extremely dangerous and can result in getting your hands and fingers caught.
When holding the shaded area (bottom of the base) by hand, be extremely careful not to get your hands or fingers caught.
Symbol Description a Resin Duct b Metal Duct c Support Plate ・ LS50-CA02S: approx. 60 kg: 132.3 lbs. (pound)
・ LS50-CA04S: approx. 61 kg: 134.5 lbs. (pound)
(Figure: LS50-CA04S)
Do not hold the metal duct, resin duct, or support duct when transporting the Manipulator. The duct part or the shaft may be damaged.
KEY POINTS
When transporting the Manipulator for a long distance, secure it to the delivery equipment directly so that the Manipulator never falls over. If necessary, pack the Manipulator in the same style as it was delivered.
When the Manipulator is used for a robot system again after long-term storage, perform a test run to verify that it works properly, and then operate it thoroughly.
Transport and store the Manipulator in the range of Temperature: −20 to +60 °C, Humidity: 10 to 90% (no condensation).
When condensation occurs on the Manipulator during transport or storage, turn ON the power only after the condensation dries.
Do not shock or shake the Manipulator during transport.