Operator Window
The Operator Window can be used as a simple interface for operators. You can configure Epson RC+ 8.0 to open only the Operator Window when started. In addition, when Remote Control is being used, the Operator Window can be displayed for monitoring purposes.
| Symbol | Item |
|---|---|
| a | Title |
| b | Status Bar |
| c | Operator Button |
| Item | Description |
|---|---|
| Status Bar | The status bar is located at the top of the window and shows emergency stop and safeguard status. In addition, if a warning is detected from the controller (such as low encoder battery), a warning label will be displayed on the right side of the status bar. If the mouse is over this label, you can see the warning error message. When there is no warning, the warning label is hidden. |
| Program to Run | Select a program to run. |
| Start | Starts the selected program. |
| Stop | Stops all tasks. |
| Pause | Pauses all tasks that are enabled for pause. |
| Continue | Continues paused tasks. |
| Robot Manager | Display the [Robot Manager] dialog in operator mode. It cannot be shown while the program is running. |
| I/O Monitor | Opens the I/O Monitor in operator mode. This window can remain open while programs are running. |
| System History | Display the [System History] window. This window can remain open while programs are running. |
| Simulator | Opens the [Simulator] window. This window can remain open while programs are running. |
| Number of Displays | Sets the number of displays to be shown. |
| Camera | Project cameras appear in a drop-down list. |
| Configure | Opens the [Configure Video Displays] window. You can set the window to be displayed as the main window. |