How to Start the Software

To start OPC UA Configurator, click Epson RC+ menu - [Setup] - [System Configuration] - [OPC UA] - [General] - [OPC UA Configurator] button.
The setting mode of the OPC UA Configurator changes depending on the connection status of Epson RC+ when you start the OPC UA Configurator.
If connected to a virtual controller, it starts in virtual controller setting mode.
In all other cases, it starts in normal setting mode.
Normal setting mode is explained on the following pages.
The basic functions of the virtual controller setting mode are similar to those of the normal setting mode. For differences from the normal setting mode, see below.

Appendix A-2: OPC UA Configurator Specifications in Virtual Setting Mode (Restrictions and Differences)

KEY POINTS

---

• If the Epson RC+ is connected to the actual controller, it is recommended to change to offline and then start OPC UA Configurator.
• OPC UA Configurator can only be opened up to one on the computer at a time.
• If the control device is "RT Motion Control", OPC UA Configurator cannot be started.