DIP Switch Settings

The board number is set by DIP switch (S2, S3) on the PG board.

The first PG board must be set as shown below:

The second PG board must be set as shown below:

The third PG board must be set as shown below:

The fourth PG board must be set as shown below:

If you purchased the PG board alone, apply the provided board number seal to the board panel before installing to the controller and be sure to keep a written record of the board number.

If the board has been already installed before shipment, the board number is properly configured and there is no need of your further configuration.

KEY POINTS

---

If you use the PG board for the conveyor tracking, use another address for the PG board of the PG motion system. For example, if the PG board 1 is used for the conveyor tracking, then use the PG board 2 for the PG motion system.