Cnv_Downstream Statement
Sets the downstream limit of the specified conveyor.
Syntax
Cnv_Downstream (conveyorNumber) , lowerLimit
Parameters
- conveyorNumber
- Specify the conveyor number as an expression or a number (1-16).
- lowerLimit
- A border on the downstream side of the tracking area
Description
By using Cnv_Downstream, you can change the downstream limit which was set in the calibration wizard. However, if skewed downstream limit is used, you cannot change the value by Cnv_Downstream.
Note
This command will only work if the Conveyor Tracking option is active.
See Also
Cnv_Upstream
Cnv_Downstream Statement Example
Cnv_Downstream 1,500