Start Mode Dialog
When the start mode is set for Auto, then a dialog is displayed at start up that allows you to change the startup mode using a password.
After a few seconds, if the [Change To Program Mode] button has not been clicked, the system will initialize and the Operator Window will be displayed.
You can disable this startup dialog using command line options. See details below.
Click the [Change To Program Mode] button. The following dialog appears.
To change the startup mode, enter your password, and then click the [OK] button. This allows authorized personnel to enter Program mode temporarily to make changes or adjustments.
You can also abort startup all together by clicking the [Cancel] button.
KEY POINTS
When you change to PROGRAM mode from this dialog, it is only temporary. The next time Epson RC+ 8.0 runs, the original start mode setting will be used.