Setting safety function parameters using a simulator

When using an edition higher than the Standard edition, some safety function parameters can be edited from the RC+ simulator. This allows you to adjust the parameter while visually checking them on the simulator. The value of the parameter that was edited with the simulator will be reflected in the safety function manager at the same time. By using both tools, the settings can be checked and adjusted more effectively.
However, the parameter must be written to the safety board from the safety function manager. It cannot be written directly to the safety board from the simulator. Therefore, after editing the parameter from the simulator, start the safety function manager, check the content, and write to the safety board. For details, refer to the following:
User's Guide - Robot Object Properties - Safety Function