Network Driver Setting Confirmation

To set the computer as the Vision PC, follow the instructions below to set the network driver after installing the Epson RC+ 8.0.

1. Open the Windows Control Panel. Click [View network status and tasks].
   

2. Click [Change adapter settings].
   

3. Select the adapter to which the GigE camera is connected by double-clicking and display the [Properties].
   

4. When “Pylon Performance Driver” is used, “Pylon GigE Vision Adapter” is shown in [Connect using:].
   Tip:
   If NIC of Intel PRO 1000 series is used, “Pylon Performance Driver” will be used. If other NIC are used, “Pylon Performance Driver” cannot be used. In this case, Pylon Filter Driver needs to be used.

5. Check that “pylon GigE Vision Driver” is registered and the checkbox is checked.
   

   Tip: If the image loading error occurs
   Check for TCP/IP offload setting in the network driver setting. If TCP checksum offload and UDP checksum offload are enabled, communication error may occur.