How to Setup a PROFIBUS DP Network

The following is a basic procedure for setting up a PROFIBUS DP network:

1. Choose station layout and pathway in your network.
   Refer to the following section for details.
   PROFIBUS DP Network Construction

2. Choose the baud rate.
   Choose the baud rate based on the network length. Select the fastest baud rate allowed for the length. Increasing network load due to slow baud rate may cause trouble including communication failure.

3. Lay cables.
   Refer to the following section for details.
   PROFIBUS DP Network Construction

4. Configure stations.
   For details, refer to respective manuals of your desired stations.

5. Turn ON the stations.

6. Install the PROFIBUS-DP board into the Controller.
   Refer to the following for the fieldbus type you have.
   

• When installing a PROFIBUS-DP master board manufactured by molex:
  Installing PROFIBUS-DP Master Board Manufactured by molex

• When installing a PROFIBUS-DP salve board:
  Installing PROFIBUS-DP Slave Board

• When installing a PROFIBUS-DP slave module:
  Installing PROFIBUS-DP Slave Module

7. Operate the PROFIBUS DP network.