Confirmation of Epson RC+ 8.0

When a PROFIBUS-DP slave module is installed to the Controller, it is recognized automatically. Confirm that Epson RC+ 8.0 has recognized the module in the following procedure.

1. Select [Setup] - [System Configuration] and display the [System Configuration] dialog box.

2. Select [Controller] - [Inputs / Outputs].

   

3. Confirm that the following items are displayed in "Fieldbus slave".
   Installed: Yes
   Inputs: 512-767 (default setting)
   Outputs: 512-767 (default setting)

4. Select [Fieldbus Slave] - [General]

   

5. Confirm that following items are displayed.
   Fieldbus Type: PROFIBUS-DP
   Node Address Configure switch Node address
   Type: Byte (default setting)
   Input Bytes: 32 (default setting)
   Output Bytes: 32 (default setting)

6. Click [Close].