Remote RS232 setting
To set the remote RS232 functions valid, follow the procedures below to configure the remote RS232.
The [System Configuration] command opens a dialog that contains several pages that are used to configure the system for the Epson RC+ 8.0 environment. Select [Controller]-[Remote]-[RS232].
Configure the necessary items for the remote RS232 control.
Click the [Apply] button to save the new setting, then click the [Close] button.
For details on the dialog setting, see below.
[Setup]-[System Configuration]-[Controller]-[Remote Control]
If you select the "Use only for monitoring" checkbox and only acquire values using Remote RS232 control, the control device setting in the next section will not be necessary.