Execution of remote RS232 control

Set the remote RS232 control available by the following procedure.

1. Open RS-232C port that is connected from client equipment to the specified port in the Remote RS232 of the Controller, using the communication parameter specified in the RS-232C port setting.
2. Send the remote start command (EOT).
3. Specify the password set in the Remote RS232 to the parameter and send the Login command.
4. Client equipment has to wait until Auto (GetStatus command response) is ON, before execution of remote command.
5. Now remote command will be accepted. Each command executes the function when the input acceptance condition is satisfied.