Debugging the Remote Control in Program Mode
You can debug programs using Remote Control from the Epson RC+ 8.0 development environment. To run programs by remote control for debugging:
- Create a program in the same manner as usual.
- Open the Run window and click the [Enable Remote I/O] button.
- Now the remote commands will be accepted.
Breakpoint setting and output to the Run window is available.
KEY POINTS
If you cannot wire the I/O, use virtual I/O mode for debugging. Remote function is also available when virtual I/O is enabled.
The program mode is active when debugging Remote Control. The behavior when an error occurs differs from that in the Auto mode.
See details below.