Remote Control Input Output Configuration

The following is the procedure to assign the remote control functions to the I/O system.

1. The [System Configuration] command opens a dialog that contains several pages that are used to configure the system for the Epson RC+ 8.0 environment. Select [Controller]-[Remote]-[Inputs] or [Outputs].

2. For each input or output you want to use for remote control, click on the Input # or Output # cell for the desired signal, then click the dropdown arrow and select a bit number in the list.

3. Click the [Apply] button to save the new setting, then click the [Close] button.

   

For details on the dialog setting, see below.

[Setup]-[System Configuration]-[Controller]-[Remote Control]