Setting Configure Switch

WARNING

---

Make sure that the power is turned OFF before installing/removing any boards or connecting/disconnecting any cables. Working with the power ON is extremely hazardous and may result in electric shock and/or malfunction of equipment.

Set the baud rates between the MAC address of the device and the master by setting the DeviceNet slave board configure switch.

1. Set the MAC address for DeviceNet slave board by setting the configure switch. Make sure that the MAC address is different from the other devices in the network. Refer to the following table for configuration.

   MAC address	Switch
   	sw3 (MSB)	sw4	sw5	sw6	sw7	sw8 (LSB)
   0	OFF	OFF	OFF	OFF	OFF	OFF
   1	OFF	OFF	OFF	OFF	OFF	ON
   2	OFF	OFF	OFF	OFF	ON	OFF
   3	OFF	OFF	OFF	OFF	ON	ON
   ⋮	OFF	OFF	OFF	OFF	OFF	OFF
   62	ON	ON	ON	ON	ON	OFF
   63 (at shipment)	ON	ON	ON	ON	ON	ON

2. Set the DeviceNet slave baud rate. Check the master configuration and set the same baud rate. Refer to the following table for configuration.

   Baud Rates	Switch
   	sw1	sw2
   125 k	OFF	OFF
   250 k	OFF	ON
   500 k	ON	OFF
   Configuration prohibited	ON	ON