Confirmation of Epson RC+ 8.0

When the CC-Link slave board is installed to the Controller, it is recognized automatically. Confirm that Epson RC+ 8.0 has recognized the board in the following procedure.

1. Select [Setup] - [System Configuration] and display the [System Configuration] dialog box.

2. Select [Controller] - [Inputs / Outputs].

   

3. Confirm that the following items are displayed in "Fieldbus slave".
   Installed: Yes
   Inputs: 512-767 (default setting)
   Outputs: 512-767 (default setting)
   

4. Select [Fieldbus Slave] - [General]

   

5. Confirm that following items are displayed.
   Fieldbus Type: CC-Link
   DP version 1.10 (default setting)
   Extended Cyclic Setting (gray out) (default setting)
   Input Bytes: 32 (default setting)
   Output Bytes: 32 (default setting)

6. Click [Close].

KEY POINTS

---

These is no Extended Cyclic Setting on CC-Link Ver1.10.

If you change Version to 2.00, you can configure Extended Cyclic Setting.