Environment

To ensure that the robot system operates and maintains maximum performance and to ensure its safe use, the robot system should be installed in an environment that meets the following requirements.

Item Conditions
Ambient temperature * 5 to 40°C
Ambient relative humidity 10 to 80% (with no condensation)

Fast transient

burst noise

2 kV or less (power supply wire)

1 kV or less (signal wire)

Electrostatic noise 4 kV or less
Altitude 1000 m or less
Environment
  • Install indoors.
  • Keep away from direct sunlight.
  • Keep away from dust, oily smoke, salinity, metal powder, and other contaminants.
  • Keep away from flammable or corrosive liquids and gases.
  • Keep away from water.
  • Keep away from shocks or vibrations.
  • Keep away from sources of electric noise.
  • Keep away from strong electric or magnetic fields
  • Keep away from explosive areas.
  • Keep away from large quantities of radiation.

* When used in a low-temperature environment near the minimum temperature specified in the product specifications, or when the unit is idle for a long period of time during holidays or at night, a collision detection error or similar error may occur immediately after the start of operation due to high resistance in the drive unit. In such cases, warm-up operation for about 10 minutes is recommended.

WARNING

Use a circuit breaker on the power cable of the Manipulator.
If a circuit breaker is not used, it may cause an electric shock and circuit breakdown caused by short circuit.

CAUTION

  • When cleaning the Manipulator, do not rub it strongly with alcohol or benzene. It may lose luster on the coated face.
  • This product should be used in an overvoltage category 2, pollution degree 2 environment.

KEY POINTS

The Manipulator is not suitable for use in harsh environments such as application work. If the Manipulator will be used in a location that does not meet the above requirements, please contact the supplier.

← Base table →

© 2026 Seiko Epson Corp.