Motion Range Setting by Pulse Range
Pulses are the basic unit of Manipulator motion. The motion range of the Manipulator is controlled by the pulse range between the pulse lower limit and upper limit of each joint. Pulse values are read from the encoder output of the servo motor.
For the maximum pulse range, refer to the following sections. The pulse range must be set inside of the mechanical stop settings.
- Max. Pulse Range of Joint #1
- Max. Pulse Range of Joint #2
- Max. Pulse Range of Joint #3
- Max. Pulse Range of Joint #4
KEY POINTS
Once the Manipulator receives an operating command, it checks whether the target position specified by the command is within the pulse range before operating. If the target position is outside of the pulse range that was set, an error occurs and the Manipulator does not move.
The pulse range can be set on the [Range] panel shown by selecting [Tools]-[Robot Manager]. (You may also execute the Range command from the [Command Window].)