Command 2105: Turns ON the output of the specified bit port
Turns ON the specified output bit.
Command Syntax
| bit | Name | Description | |
|---|---|---|---|
| Parameter 1 | 15 | bitNumber | Specifies the bit number to be turned ON. |
| 14 | |||
| ｜ | |||
| 1 | |||
| 0 |
Response Syntax
Refer to the following.
Description
The command turns ON (sets to 1) the specified output.
CAUTION
- Output bits configured as remote
If an output bit which was set up as remote is specified, an error will occur. Remote output bits are turned ON or OFF automatically according to system status. - When an emergency stop occurs
The Controller has a feature which causes all outputs to go off when an E-Stop occurs. To keep the setting in emergency, follow the procedure described in the following.
“Epson RC+ User’s Guide” - [Setup]-[System Configuration]-[Controller]-[Preferences]-Output port OFF with emergency stop”
Example
When turning ON the output bit number 15.
| Command | Response |
| 0839H 000FH | 0839H 0000H 0000H |