Part Feeding Window

The Part Feeding dialog is opened by selecting Epson RC+ 8.0 Menu - [Tools] - [Part Feeding].

Here you can perform the following actions.

1. Configure part parameters.
   
2. Calibrate the feeder and manual adjustment/test. Anyone can easily calibrate by following the on-screen instructions. Manual adjustment / test allows fine adjustment of feeder parameters and can be easily tested with the touch of a button.
   

KEY POINTS

---

The Part Feeding window will not appear if Epson RC+ is not connected to the Controller. An error will occur when attempting to open the Part Feeding window using a virtual controller or when offline.