Wiring Example of Vision Conveyor Tracking System

Example of Hardware Trigger (Asynchronous Reset Mode)

Wire the trigger terminal of the camera and the encoder latch terminal of the PG board to the I/O output of the controller. The PG board detects the trigger when the I/O output turns from OFF to ON. Set the camera so that it also detects the trigger when the I/O output turns from OFF to ON.

For software trigger, it is not necessary to connect the trigger terminal of the camera to the encoder latch terminal of the PG board.

Wiring example of the hardware conveyor trigger

(CV2, Controller I/O output pin10 and Counter 1 are used)

• When using conveyor tracking option kit B

  

• When using PG board