Controller Connection

For each project type, you must select a connection to a robot controller when the Project Wizard asks you to select a controller. You can select from existing connections, or you can create a new connection.

Select an existing connection

Select a connection in the list of connections, and then click the [Next] button.

Create a new connection

Click the [New Connection...] button. This opens the Connection Wizard. Follow the steps in the wizard to add a new controller connection. When the wizard is completed, the new connection will be selected in the connection list. Click the [Next] button.

When the connection type is Ethernet, enter the IP address. If the controller connection requires a password, enter the connection password. Click the [Next] button. Epson RC+ will attempt to connect with the controller. If unsuccessful, an error message will be displayed. Check the IP address, password, connection and network cables. Click the [Next] button again to start the connection.

Click the [Finish] button to create a new connection. The new connection will be added to the connection list in the project wizard and it will be selected.