Purge
This screen configures settings relating to purge.
| Items | Description | |
|---|---|---|
| Enable Purge | Select this check box for enabling purge. | |
| Purge Location | Sets the location for purge. Parts will move (shift) in the arrow direction during the purge operation. Select either A, C or D. The location that can be set differs depending on the feeder model. IF-80: A IF-240, 380, 530: C, D | |
| Purge Gate | Set the Purge Gate settings. | |
| Enabled | Select this check box for enabling the purge gate for the part. By default, the this check box will be checked if the "Purge gate installed" check box was checked in the Epson RC+ 8.0 Menu - [Setup] - [System Configuration] - [Controller] - [Part Feeders]. | |
| Purge Gate Closed | Status indicator for the Purge Gate sensor Closed : Green, Not closed : Gray | |
| Open / Close | Allows opening and closing of the Purge Gate | |
KEY POINTS
The Purge Gate groupbox will only be accessible if the "Purge gate installed" check box was checked in the Epson RC+ 8.0 Menu - [Setup] - [System Configuration] - [Controller] - [Part Feeders].
KEY POINTS
If you try to move to another tab when the Purge Gate is not closed, the dialog "Purge gate will now be closed. Continue?" is displayed. Press OK to close the Purge Gate.