Hopper - Test & Adjust
The Hopper test and adjust page is always shown if one or more hoppers are used for the part.
Refer to the following for further details.
How to Adjust the Hopper
Description of display items
| Items | Description |
|---|---|
| Amplitude | Set the strength of the amplitude of the vibration. Unit: % |
| Duration (IF-80, Gen.2 hopper only) | Set the duration of the vibration. Unit: ms |
| Frequency (For IF-80 only) | Displays the frequency of the vibration. Unit: Hz |
Guidelines for adjustment
Refer to the following section for further details on adjustment.
How to Adjust the Hopper
KEY POINTS
- If two hoppers are used for a part, then a dropdown is provided on the Hopper page to allow selection of which hopper to use for test and adjust.
- If changes are made, the [Apply] button must be clicked before changing the hopper number. If the hopper number is changed and there are pending changes for the currently selected hopper, then a message is displayed that [Apply] or [Restore] is needed, and the hopper selection remains unchanged.