[Setup]-[System Configuration]-[Controller]-[Remote Control]-[Inputs] Page
Use this page to configure the controller remote control inputs.
| Item | Description |
|---|---|
| Input Signal | Displays the input signal. See details below. |
| Input # |
Select an input bit to use for the corresponding input signal." Select Not used" to disable the remote output. For example, "Start" is assigned to I/O input bit 0 in the above dialog. Select "Not used" to use this as a normal I/O input. |
| Default |
Click this button to set the default remote inputs. First, a dialog box will be displayed asking you which type of inputs to use for defaults: Standard, Extended I/O, Fieldbus master, or Fieldbus slave I/O. You can also select the [Clear All] button to set all remote inputs to Not used. |
| Load | Reads the assigned remote inputs and outputs from a file on the PC and save it in the controller. |
| Save | Saves the assigned remote inputs and outputs shown in the dialog to a file on the PC. |
KEY POINTS
Both the remote inputs and outputs are loaded or saved together when using [Load] or [Save].