[Setup]-[System Configuration]-[Controller]-[RS232]-[PC] Page

Use this page to configure the RS232 ports on PC.

To configure an RS-232 port

1. In the Epson RC+ 8.0 menu, select [Setup]-[System Configuration]-[RS232]-[PC]. Select a port from the tree.
2. Select the [PC port] and change the settings as desired.
3. Set the [Enabled] checkbox.
4. Click the [Apply] button to save the new settings.
5. Click the [Close] button to close the dialog.

KEY POINTS

---

If set to a virtual port, the [Communication response / Output folder...] button appears. This opens the communication input/output file folder. See details below.

Restriction on SPEL+ command execution