[Setup]-[System Configuration]-[Controller]-[TCP/IP] Pages

There is one page for each TCP / IP port in the controller.

To configure a TCP/IP port

1. In the Epson RC+ 8.0 menu, select [Setup]-[System Configuration]-[TCP/IP]. Select a port from the tree.
2. Enter the IP address in the [IP Address] dialog box.
3. Enter the TCP/IP port number in the [TCP/IP Port] box. This must be the same port number that is used on the host device. It must be different from any of the other TCP/IP port numbers used for the other TCP/IP ports.
4. Change the other settings as desired.
5. Click the [Apply] button to save the new settings.
6. Click the [Close] button to close the dialog.

KEY POINTS

---

If set to a virtual port, the [Communication response / Output folder...] button appears. This opens the communication input/output file folder. See details below.

Restriction on SPEL+ command execution